Operating And Error Indication; Fig. 6-5: Leds To Indicate Operations And Errors On The Front Panel - Bosch Rexroth IndraControl VDP 16.1 Series Project Planning Manual

VDP 16.1, VDP 40.1 and VDP 60.1
6.2

Operating and Error Indication

DOK-SUPPL*-VDP16/40/60-PR02-EN-P
In the upper part of the front panel there are 4 LEDs to indicate the device
states and errors. Depending on the variant the front panel provides
labeled LEDs or illuminated symbols. Start the measures specified in the
following table, if one of the succeeding LEDs indicates an error or a note.
Symbol / Indicator Meaning
LED
LED Normal mode
green
LED OFF No supply voltage
230/115 VAC or 24 VDC
Power
LED Hard disk access
yellow
HDD
LED Temperature in the safe
green range
Temperature > 50 °C
LED red
flashing
Temp
LED OFF Normal mode
LED red IPC is currently operating
in battery mode, i. e. no
power supply available!
UPS
LED red Battery pack discharged,
flashing defective or not connected
Fig. 6-5: LEDs to indicate operations and errors on the front panel
Note: Depending on the used industrial PC not all LEDs are
activated. Further information you will find in the respective
documentation of the IPC.
Display and Operating Components
Measure
-
Check supply voltage at
the power supply unit!
-
Reduce ambient
temperature (surrounding
air temperature)!
Check fan at the PC!
-
Restore power supply and
initiate controlled IPC
restart!
Check battery pack!
Maintain the charging time
of 5 hours!
6-5