Operating System; Commissioning - Bosch Rexroth IndraControl VEH 30.1 Project Planning Manual

Project Planning Manual | Rexroth IndraControl VEH 30.1
1.2

Operating System

1.3

Commissioning

Connecting the device
Fig.1-3: Front view: IndraControl VAC 30.2
For license reasons IndraControl VEH 30.1 type devices are only delivered with
already installed operating system. For further information about the operating
system please refer to chapter 9 "Software" on page
Please mount the IndraControl VAC 30.2 connection module according to the
specifications in chapter 5 "Dimensions" on page
connection module to the following components:
● Voltage supply
● STOP circuit
● Enabling circuit
● Network
Before commissioning the IndraControl VEH 30.1 you have to ensure that the
installation, especially the safety devices, are in a proper status.
Before commissioning the IndraControl VEH 30.1 do observe that
the STOP pushbutton is not pressed. The connection of an Indra‐
Control VEH 30.1 with pressed STOP pushbutton, shuts down the
installation.
For connecting the IndraControl VEH 30.1 put – as shown in
entation at the IndraControl VAC 30.2" on page 4
without effort with an angle of 45° to the horizontal on the flange of the Indra‐
Control VAC 30.2 connection module. Only if the connector snaps in properly,
Electric Drives | Bosch Rexroth AG
and Controls
System Presentation
47.
23. After this connect the
– the angled connector
3/68
fig. 1-4 "Plug ori‐