Operating System; Commissioning - Bosch Rexroth VCH 08.1 Manual

8/117 Bosch Rexroth AG
System Presentation
1.7

Operating System

1.8

Commissioning

For license reasons IndraControl VCH 08.1 are only delivered with already in‐
stalled operating system. For further information about the operating system,
please refer to chapter 9 "Software" on page
Mount the IndraControl VAC 30.1 connection module according to the specifi‐
cations in chapter "Dimensions". After this connect the connection module to
the following components:
● Voltage supply
● Stop circuit and emergency stop circuit
● Enabling circuit
● Network
Before commissioning the IndraControl VCH 08.1 the operator has to assure
that the plant, especially the safety devices, are in a proper state.
NOTICE
Before putting the IndraControl VCH 08.1 into operation do observe that the
STOP button or emergency stop button is not pressed.
For connecting the IndraControl VCH 08.1 put the connector without effort to
the flange of the VAC connection module. Observe the latch position of the
connection. Older connecting cables with angled plug, are fitted in a 45° angle
to the horizontal. Only if the connector snaps in properly, the correct position is
reached. Now turn the knurled nut with slight pressure on the flange. Devices
with red-yellow emergency stop button are equipped with a bayonet connector
and snap in automatically.
NOTICE
While the connector is screwed on a VAC connection module, a relay activates
the stop button. In this way the IndraControl VCH 08.1 is supplied with voltage.
Screw the knurled nut as far as the rubber seal is completely covered and the
end position is reached to ensure the optimal connection of the contacts and
to achieve the specified degree of protection.
DOK-SUPPL*-VCH*08.1***-PR02-EN-P
Rexroth IndraControl VCH 08.1 Hand-held Terminal
91.
Shutdown of the plant due to connecting a In‐
draControl VCH 08.1 with pressed stop button
or emergency stop button.
Loss of specified degree of protection due to
incorrect connection of contacts.