DOK-SUPPL*-VCH*08.1***-PR02-EN-P
Rexroth IndraControl VCH 08.1 Hand-held Terminal
Calibration Potentiometer
Display Settings
Zero Point Setting of the Handwheel
The "Potentiometer" tab is contained in the "Config Tool", see
Configuration Tool (Config Tool)" on page
Fig.9-11:
Dialog for potentiometer calibration
Start the potentiometer calibration by selecting the "Calibrate" button, see
9-11 "Dialog for potentiometer calibration" on page
the same way like the potentiometer setting. For verification purposes the cur‐
rent value is output also as number. After having finished the calibration, this
number displays the current value of the potentiometer (value range: 0 to 127).
The "Display/Touch" tab is contained in the "Config Tool", see
" Configuration Tool (Config Tool)" on page
Fig.9-12:
Dialog for display settings
In this dialog the brightness and contrast can be set.
The "Handwheel" tab is contained in the "Config Tool", see
Configuration Tool (Config Tool)" on page
Bosch Rexroth AG
chapter 9.5.3 "
100.
101. The slider moves in
chapter 9.5.3
100.
chapter 9.5.3 "
100.
101/117
Software
fig.