Silvercrest SVEB 160 A1 Operating Instructions Manual page 28

Let the device cool down completely be-
fore winding up the power cable.
Ensure that the power cable cannot be
trapped or crushed.
To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
Disconnect the mains plug from the wall
socket ...
...after every use,
... if there is a fault,
... when you are not using the device,
... before you clean the device and
...during thunderstorms.
DANGER - Fire hazard
Never leave the device unattended
while it is plugged in.
Use the device on a stable, level and
heat-resistant surface.
Never cover the device when connect-
ed due to possible overheating and fire
hazard!
Do not use the device in the vicinity of
flammable materials or flammable gas-
es.
DANGER! Risk of injury
through burning
The welding wire becomes very hot dur-
ing operation. Do not touch the hot
welding wire.
Allow the device to cool down com-
pletely before you clean it or put it
away.
DANGER! Risk of injury
Ensure that you never vacuum your skin,
hair or clothing with the adapters.
26 GB
DANGER caused by
insufficient hygiene
For a carefree enjoyment of your vacu-
um-sealed food, you should always
comply with the following hygiene tips:
- During the preparation and packag-
ing of the food make sure that the en-
tire equipment is perfectly clean.
- Clean the vacuum sealer and all de-
vices thoroughly after use.
- Perishable food should be cooled or
frozen immediately after sealing.
- After thawing or heating perishable
food, this must be consumed immedi-
ately.
WARNING! Risk of material damage
The device needs to cool down after the
sealing and/or vacuum-packing pro-
cess.
To protect the device, an automatic lock
is briefly activated between two sealing
processes. The duration of this lock de-
pends on the function being used.
Only use special plastic film bags that are
suitable for use with vacuum sealers /
bag sealers.
Never place the device on hot surfaces
(e.g. hot plates) or near to heat sources
or open fire.
Ensure that no liquid is sucked in during
the extraction of air.
The device is fitted with non-slip plastic
feet. As furniture is coated with a varie-
ty of different varnishes and acrylics,
and treated with different cleaning
agents, it cannot be completely ruled
out that components are contained in
some of these substances that could
damage and soften the plastic feet. If
necessary, place a non-slip mat under
the device.
Do not clean using sharp objects or
abrasive cleaning agents.