Cancelling The Process; Film Bag (Without Valve); Requirements On The Film/Bags; Producing A Bag - Silvercrest SVEB 160 A1 Operating Instructions Manual

Vacuum sealer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 24
8.2

Cancelling the process

You can cancel any process early by
pressing the stop button
9. Film bag (without
valve)
9.1
Requirements on the
film/bags
-
You can use tubular film or complete
bags.
-
The film bag must not be wider than 30
cm.
-
The film bag must have dots/knobs or
grooves on one side. Smooth film bags
are not suited for sealing.
-
The thickness should be between 0.17
and 0.29 mm (170 - 290 μm).
-
When buying the film bag, check the
temperature range it is suited for. The
ideal range is between -20 °C and
+ 110 °C. Such film bags can be deep-
frozen or boiled. The film supplied is
suitable for this application.
-
You will find those data on the packag-
ing of the film or bag.
9.2

Producing a bag

DANGER! Risk of injury from
burning!
The welding wire 15 becomes very hot
during operation. Do not touch the hot
welding wire 15.
NOTE: if you use finished bags, these steps
do not apply.
1. Open the compartment 19 and insert
 8.
2. Unwind the length of vacuum bagging
3. Press down the film cutter 18 while
the film bag roll as shown.
tube from the roll that you require for your
bag and close the compartment 19. Re-
garding the length of the bag, remember
that a space of approx. 7 to 8 cm to-
wards the top should be left after filling.
moving it over the vacuum bagging
tube to cut the piece. To ensure that the
film lies flat, hold the vacuum bagging
tube firmly with one hand.
29
GB

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

347713 2001

Table of Contents