Table of Contents
Advertisement
Test Run
Step
Check the power supply
1
voltage
Turn the ground fault circuit
2
interrupter on.
Turn the power switch "ON".
3
(page 4)
Insert your hands to check if air is
4
being blow. (page 4)
Press the air speed switch while
5
one hand is inside. (page 12)
Turn the heater switch "ON".
6
(page 12)
7
The air speed light and heater light turn off after about 10 seconds. When the air speed switch or heater switch are
pressed again, the lights in the display section turn back on in the state where the settings have been made.
Caution
If the power light flashes, turn the power switch "OFF", check that power light is off, and then wait for 1 minute before
switching the power back "ON".
What to check for
Is the proper power being used?
(JT-MC206GS-W type:
Single-phase 220 – 240V AC
Incorrect power supply may cause malfunctions or low
wind power.
Are any lights in the display on?
Is the air blowing?
Has the air speed changed?
Is warm air blowing?
( Even if the heater switch is "ON", the heater may not operate if
it is used continually.)
※ As the heater is a simple heater, the air may not feel so
warm if the room temperature is low (20 C or below).
Is the unit mounted securely without any vibration or abnormal
noises?
− 10 −
Check
)
Advertisement
Table of Contents
