Mitsubishi Electric Jet Towel JT-MC206GS-W-E Installation Manual page 8

Installation method - continuation
1. Push the power cable for exclusive
wiring through the power cord hole
at the rear of the base.
4
2. Engage the base with the 2 hooks on
the installation panel.
3. Check that the power cable is not
trapped behind the base.
Warning
Single-phase 220-240V AC
Using the incorrect power supply may cause fi res, electric shocks
or malfunctions.
Wire the power cable to the terminal block.
(No polarity)
1. Remove 12mm (single wire) or 8mm
(stranded wire) of wire sheath from
the end.
2. Fix the power cable to the terminal block.
When stranded wire is used for the power
cable, attach an insulated ring tongue terminal
using an appropriate tool.
Proper torque is 1.5N·m
5
3. Check that the power cable is
securely fi xed to the terminal block.
4. Use the cord clip mounting screw
hole to fi x the power cable with the
accessory cord clip and mounting
screw (4 × 14).
Proper torque is 1.5N·m
Fix it where the external wire sheath of the
power cable is when it is fixed in the cord clip
mounting position.
Do the wiring so that the power cable goes
through the right side of the circuit case.
The main unit panel may not be able to be
attached if it is above the circuit case.
Panel hooks
(2 locations)
Installation
panel
Conduit
box
power is used.
Single wire
■
Stranded wire
■
Insulated ring
tongue terminal
Terminal block
Base
Circuit case
Base
Circuit case
− 8 −
Power cord hole
Power cable
Caution
Make sure that the main unit
does not fall as the base is not
attached to the wall with screws.
Injuries may be caused if the unit
falls off the wall.
Terminal block
Power cable
Power cable
Cord clip
(Accessory)
Power cable
Power cord hole
Base
Unit (mm)
Screw
L
N
Cord clip
mounting
screw hole
Cord clip
mounting screw
(4×14)
(Accessory)