Table of Contents
Advertisement
Initial setting checks - Continuation
■ Turning the heater on
1
Open the front cover.
2
Press the air speed switch or the heater switch
and let the settings light turn on.
3
Turn the heater switch "ON".
※ The heater may not operate during continued use as there is
the danger of scalding when the temperature of the warm air
rises.
The air may not feel warm when the room temperature is low
(20 C or below).
Checking the settings
The heater light and air speed light turn off after about
10 seconds after their settings are made (to save energy).
To check the settings, press either the heater or air speed
switch.
■ Adjusting the air speed
1
Open the front cover.
2
Press the air speed switch or the heater switch
and let the settings light turn on.
3
Press the air speed switch.
The modes change between "Low" and "High", and the
air speed light turns on each time the air speed switch is
pressed.
Refer to "Settings and drying times guide".
Checking the settings
The heater light and air speed light turn off after about
10 seconds after their settings are made (to save energy).
To check the settings, press either the heater or air speed
switch.
■ Settings and drying times guide
Settings
Drying times guide
High
(approx.) 13 – 15 seconds
Low
(approx.) 24 – 27 seconds
※ Drying times are based on Mitsubishi measurements. (50mg of water per hand)
※
Noise
(approx.)
64dB
(approx.)
54dB
Tokyo Building 2-7-3, Marunouchi, Chiyoda-ku, Tokyo 100-8310, Japan
Front cover
Open
Front cover
Air speed
switch
When drying quickly
When keeping the noise level down during operation
− 12 −
Open
Heater switch
Heater
light
Heater
switch
Air speed light
Air speed switch
Use
Advertisement
Table of Contents
