Table of Contents
Advertisement
Installation (continued)
(when using the ceiling mount bracket ET-PKD120H (for high ceilings))
A
A
1 Secure one end of the wire rope with a
captive washer screw (M6×20) to "A" on the
projector as shown on the left.
Attention
z Be sure to use the supplied flat washers and
wire rope.
z At this step, please keep the wire rope
through the opening of the mounting bracket
base.
Note
z One of the two supplied washers with this
product is for the fixing of the wire rope to the
projector and the other is for the fixing of the
wire rope to the ceiling.
2 Mount the projector with the ceiling mount
bracket ET-PKD120H (for high ceilings) to
the angle adjusting bracket.
3 Mount the projector to the ceiling.
Attention
z For the combinatioin of this product and
the ceiling mount bracket (sold separately),
please refer to the installation instructions of
the ceiling mount bracket ET-PKD120H (for
high ceilings).
4 Pass the wire rope through the hole as
shown in the figure on the left.
ENGLISH - 9
Advertisement
Table of Contents
