Table of Contents
Advertisement
5.3 Tool Inspection
WARNING: Before using, inspect the scope and correct any problems to reduce
the risk of serious injury from electric shock and other causes and prevent tool
damage.
•
Make sure the power is OFF.
•
Clean any oil, grease or dirt from the tool, especially on the buttons and ports.
This helps prevent the tool from slipping from your hands.
•
Inspect the imager head lens for condensation. To avoid damaging the tool,
do not use the tool if condensation forms inside the imager head. Let the water
evaporate before using again.
•
Inspect the full length of the cable for cracks or damage.
•
Make sure the connections between the display unit and imager head and
cable are tight. All connections must be properly assembled for the cable to be
waterproof.
NOTE: Please check following methods to avoid injury.
•
FOR WALLS:
electrical circuit breaker to the whole house before using the tool.
•
FOR PIPES:
have a qualified electrician check the pipe before using.
•
FOR AUTOMOBILES:
inspection. Metal and liquid under the hood may be hot. Don't get oil or fuel
on the imager head.
Page 16
For inspecting the inside of walls, be sure to close the
If you suspect a metal pipe could contain electric cables,
Be sure the automobile is not running during
Original Language Version
VS8197.V2
Issue: 1 - 23/11/11
Advertisement
Table of Contents
