Advertisement
PREPARING
FOR IHSTMMTION
For ducting through the floor.
e
iner
"The blower may be rotated for horizontal or verti=l direction
by loosening nuts around the blower
inlet,
accessible inside the
ventilation chamber.
PREPARING
FOR IHSTALMTIOH
For ducting through the back wall.
9%"
23.81 cm
'The blower may be rotated for horizontal or vertical direction
by loosening nuts around the blower inlet, accessible inside the
ventilation chamber.
i,
4
b
4
k
\
i
3 (7.62 cm)
+
5/8~~
.69 cm
limum
!arance
A
30,16cm ~
IMPORTMT
Dimension "Y-Provide
Z min. (5.08 cm)
—---
cabinet clearance to motor for cooling pu~oses.
N~:
mere possible, W (15.24cm) is
recommended for motor/blower service.
Side Clearance—Grillsinstalled near a side
wall should allow a mhimum clearmce of
6 (15.24cm) for best venting performance, but
may be safely installed as near as 1" (2.54
cm)
from a side wall if required by space limitations.
Electrical Hooku~fie
unit should be properly
circuit protected md wired according to local
electrical codes. See electrical wiring information
on back. Unit power requirements are located on
the data plate.
Ducting Requirements—Use of a wall cap
required. See Step 5 "Install the Ductwork."
You must allow room enough to remove and
empty grease containers.
14
Advertisement
