Installing, connecting, commissioning
4.1 Preparing installation
4.1.3.2
Upright mounting on DIN rails
Upright mounting on DIN rails is suitable for vertical mounting of the device. The mounting
bracket for this permits space-saving installation with wall mounting.
Requirements
• Mounting bracket
Note
Use only the screws supplied to mount the mounting bracket. Longer screws can damage
the interior of the device
• A T10 screwdriver
• Two wall plugs and two screws
Procedure – upright mounting on DIN rails
24
1.
Place the mounting bracket on the rear of the
device.
2.
Fasten the mounting bracket with two screws
supplied.
3.
Place the device on the mounting bracket onto the
DIN rail.
Equipment Manual, 07/2020, L1V30579222003-03
7KN POWERCENTER 3000