Mounting On Din Rails - Siemens SENTRON 7KN POWERCENTER 3000 Manual

Installing, connecting, commissioning
4.1 Preparing installation
4.1.3.4

Mounting on DIN rails

The standard rail mounting is suitable for horizontal and vertical mounting of the device.
Requirements
• A SIEMENS 35-mm DIN rail TH35-15 in accordance with EN 60715:2001
The DIN rail is mounted.
• A DIN rail clip
Note
Use only the screws supplied to mount the DIN rail clip. Longer screws can damage the
interior of the device
Tools
• A T10 screwdriver
Procedure – mounting
Procedure - removal
1. Press the device downward until the lower DIN rail guide releases the device.
2. Swing the device away from the DIN rail.
3. Remove the device.
See also
Dimensional drawing of basic device (Page 127)
26
1. Place the DIN rail on the rear of the device.
Pay attention to the position of the springs of the
DIN rail clip.
2. Fasten the DIN rail clip with the 4 screws supplied.
3. Place the device on the DIN rail clip onto the DIN
rail from above.
If you position the device so that it is skewed, the
DIN rail clip will not engage.
4. Press the device downward onto the DIN rail until
the DIN rail clip engages below.
5. Check that the device fits closely on the DIN rail.
6. For vertical standard rail mounting: Mount a DIN
rail grounding clip below the device.
Equipment Manual, 07/2020, L1V30579222003-03
7KN POWERCENTER 3000