RECEIVING, INSPECTION AND HANDLING
RECEIVING AND UNPACKING
The OEM components are subjected to factory
production alignment and testing prior to being
packed and shipped.
ACCEPTANCE INSPECTION
Confirm that the power cell and withdrawable
contactor carriage (if furnished) are complete,
correct as specified and undamaged from
shipment and handling.
Upon receipt of the equipment, do the following:
1) Make an immediate inspection for damage
which might have occurred during shipment.
If damage is discovered, it should be noted
with the carrier prior to accepting the
shipment, if possible.
2) Carefully unpack the equipment sufficiently
to check for missing parts or concealed
damage.
3) Keep the components upright.
Never lay the power cell or
the contactor carriage on
CAUTION
their sides or upside down.
This may cause damage.
4) File a claim with the carrier for any damaged
or missing items and immediately notify the
nearest Toshiba representative.
Do not install or energize
equipment that has been
damaged. Damaged
WARNING
equipment can fail during
operation, resulting in fire
and explosion.
HANDLING AND MOVING THE POWER CELL
When handling and moving the power cell, the
suspension technique shown in Fig. 15 should
be used.
45°
Fig. 15 Lifting Method for Power Cell (Fixed-Type
and Withdrawable Contactor)
Page 13
LIFTING POINT
A/2
A
FRONT