Scaling Process; Adjusting The Program To Your Welding Task - Bosch WT PSI 6 Series Technical Information

Commissioning
10.5

Scaling process

10.6

Adjusting the program to your welding task

10-8
PSI 6XXX.190 W1
For quality assurance, you should adjust your welding equipment to your real conditions
by means of Scaling.
The following parameters will be adjusted through Scaling:
- toroid sensitivity
- conversion factor for pressure output
- zero shift for pressure output
Select, e.g., Starting Window - Scaling.
D
Check the quality of your spot welds.
D
The actual current values of the spots welded are displayed in various windows, e.g. in
the Programming - Sequence - Actual Values window.
If necessary, adjust the following programmed values to your requirements:
D
- [%I] and [Weld Time]
- Type and number of [Weld Times]
- Current upslope and downslope times [Slope]
1070 080 086-101 (01.01) GB