Hitachi SJ-FB Manual page 5

4.2 Function Explanation of the Terminal
Terminal
Pulse line position
command input
Encoder signal in-
put
Pulse train position
command input
permission signal
(Note 1)
Orientation signal:
(Note 1)
LAD cancel signal:
(Note 1)
Position deviation
clear signal:
(Note 1)
Encoder signal
output
Power supply for
encoder
Positioning com-
pletion signal
(Note 2)
Speed deviation
excessive signal
(Note 2)
Zero speed signal
(note 2)
(Note 1): Valid when LAC is assigned to an intelligent input terminal of the main body (SJ300).
(Note 2): Valid when POK is assigned to an intelligent output terminal of the main body (SJ300).
(Note 3): Refer to the code setting method of SJ300
Code
Pulse train input (see page 16)
•Mode 0 : 90 degree phase difference pulse
•Mode 2 : Forward pulse/Reverse pulse
SAP
•Mode 1 : Forward/Reverse signal, pulse train
SAN
ON/OFF of the terminal resistance on the option
SBP
board can be done by the dip switch.
SBN
(Built in terminal resistance 150 ohm)
Mode setting is done at the pulse mode selection
(P013)
EAP
EAN
EBP
A, B, Z: rotary encoder signal input
EBN
EZP
EZN
Position control with pulse train in-
STAT put is valid when STAT is Turned
ON. (Note 3)
Turning ON for orientation opera-
ORT
tion. (Note 3)
Turning ON for canceling LAD.
LAC
(Note 3)
Turning ON for clearing position
PCLR
deviation counter. (Note 3)
AP
AN Outputting the Inputted encoder signal (ratio
BP 1:1).
BN
EP5
DC +5V power supply
EG5
Used for position control or orienta-
tion.
POK Output when the subject comes
within the specified range (P017).
(Note 3)
Output when the real rotation speed
DSE deviates over from command speed
(P027). (Note 3)
Output when the real rotation speed
ZS becomes zero speed detection level
(C063). (Note 3)
Chapter 4 WIRING AND CONNECTION
Function
5
Common electric
terminal specification
DC5V receiver input
(based on RS-422
standard)
Photo coupler input
(Correspondence to
the DC5V line driver
type rotary encoder)
Photo coupler input
(Refer to a main
CM1
body intelligent input
terminal.)
DC5V line
output (based
RS-422 standard)
EG5 150mA max
Open collector out-
puts
CM2 (Refer to a main
body intelligent input
terminal)
driver
on