Fujitsu BS2000 SE Series Manual page 14

Powering on further units
The powered-off Server Unit is powered on. As soon as the Power status for the Server Unit
is On and the monitor or Native BS2000 system have reached the status INIT_ONLY, you
can boot the BS2000.
i
Powering on additional Units (redundant MU, HNC)
For BS2000 operation on an SU /390m the following units should also be powered on:
In the case of MU redundancy the second MU should also be powered on. Only in this
●
way will it remain possible to continue operating the SVP of the SU /390 if the first MU
crashes. The SE Manager on the second MU will also remain available.
To enable the BS2000 systems to communicate over the IP network and ensure access
●
to Net-Storage is possible, the HNC must be powered on. Redundant existing HNCs
should also be powered on.
14
After a Server Unit has been powered on, depending on the operating mode set,
the Native BS2000 system or the VMs are started up if an automatic startup (auto
IPL) has been configured for this purpose.
Powering on, starting up BS2000, powering off
U41857-J-Z125-2-76