Sony HDVF-C35W Maintenance Manual page 20

Page Menu Items
S04 FUNCTION2 SECOND VF
MAG REL TIME
CHAR LEVEL
S05 TEST SIGNAL TEST SIGNAL
COLOR SELECT
TEST LEVEL
S06 HOURS METER RESET METER
OPERATION
TOTAL
*1 : Set this to ON only when using the device as the second VF by connecting it to the EXT I/O (20P) connector of HDC-950 or HDC-
930. (No setting change is required when using the device alone.)
In this case, a dedicated VF connection cable and the corresponding camera settings are needed.
Contact your nearest SONY Office/Service Center for details.
No setting change is required when connecting the device to the EXT I/O (20P) connector of HDC-F950.
*2 : Refer to AUTO RELEASE of OPERATION MENU 03 MAGNIFICATION.
*3 : This parameter will always start in OFF when the power is turned on.
*4 : Place the cursor mark "→" on "EXEC" and press the ENTER switch to move to the following operation screen.
Place the cursor mark "→" on "YES" and press the ENTER switch to perform reset.
VF MENU
S06 HOURS METER
RESET OK?
RESET METER
OPERATION
TOTAL
2-4 (E)
Setting ( indicates the default)
[OFF], ON
1 to [5] to 10
0 to [192] to 255
[OFF], BARS, SAW, RAST
[W], R, G, B, Y, C, M
0 to [255]
EXEC
Display only
Display only
YES NO
: EXEC
:65534H
:65534H
Function
Switches the IIC address used as
the second VF
OFF : Normal
ON : When used as the second
VF *1
Sets the time it takes to return
from the enlarged view to the
normal view when MAG AUTO
RELEASE is set to AUTO *2
Sets the brightness of the display
characters of menu.
*3
Sets the internal test signal
OFF : Does not output the test
signal
BARS : Outputs a color bar signal
SAW : Outputs a saw-tooth wave
test signal
RAST : Outputs a rectangular test
signal
Selects a display color when a
rectangular test signal is selected
Sets the signal level when a
rectangular test signal is selected
Resets the OPERATION time
Press the ENTER switch to move
*4
to the operation screen
Displays the total power-on time
(resettable)
Displays the total power-on time
HDVF-C35W