2 Connect a coaxial cable between BREAK IN and TRIGGER OUT.
3 Set all of the switches to CLOSED.
4 Use a terminal emulator to connect to the emulation probe.
5 Enter the pv 1 command.
See Also
On a good system, the RESET LED will light and the BKG and USER
LEDs will be out.
This is standard RS-232 at 9600 baud which can be connected directly
to a 9 pin RS-232 interface that conforms to the IBM PC-AT 9 pin
standard.
Options available for the "pv" command are explained in the help
screen displayed by typing "help pv" or "? pv" at the prompt.
Here are some examples of ways to use the pv command.
To execute both tests one time:
pv 1
To execute test 2 with maximum debug output repeatedly until a Ctrl-c
is entered:
pv -t2 -v9 0
Chapter 6: Solving Problems
Solving Emulation Probe Problems
139