Table of Contents
Advertisement
Chapter 6: Solving Problems
Solving Emulation Probe Problems
host computer for the location and action of the "ping" utility. If the
emulator fails to respond to the "ping" request, verify that the LAN
parameters (IP address and gateway address) are set correctly and
that your host computer recognizes the IP address of the emulator. If
all else is good, then failure to respond to ping indicates a faulty
emulator.
Test 4: Break In and Trigger Out BNC Feedback Test
R>pv -t4 -v2 1
Testing: HPE3499B Series Emulation System
Test # 4: Break In and Trigger Out BNC Feedback Test
Break In not receiving Break Out HIGH
FAILED Number of tests: 1
Before returning to HP, check to ensure that you have connected a
good Coaxial cable between the two BNCs. If the cable is good, the
emulator is bad.
TEST 5: Target Probe Feedback Test
TEST 6: Boundary Scan Master Test
TEST 7: I2C Test
TEST 8: Data Line Test
If these tests are not executed, check that you have connected the
emulator loopback test board.
If these tests fail, return the emulator to HP for replacement.
142
failed!
Number of failures: 1
Advertisement
Table of Contents
