Chapter 1: Installing the Emulation Probe
Updating Emulation Probe Firmware
Updating Emulation Probe Firmware
Firmware gives your emulator a "personality" for a particular
microprocessor or microprocessor family.
After you have connected the emulation probe to a LAN, you may need
to update the firmware to give it the right personality for your
microprocessor.
You must update the firmware if:
• You need to change the personality of the emulation probe for a new
processor.
• You have an updated version of the firmware from HP.
To display current firmware version
information
• Use telnet or a terminal emulator to access the built-in "terminal
interface" and use the ver command to view the version
information for firmware currently in the emulation probe.
To update firmware for an emulation probe
To update the firmware, you must have access to the World Wide Web
and a PC or a workstation connected to your emulation probe.
1 Download the new firmware from the following World Wide Web
site:
http://www.hp.com/go/emulator
The firmware will be in the "Technical Support Information" section of
this web site.
2 Follow the instructions on the web site for installing the
40