Table of Contents
Advertisement
INSTALLATION ( NEW CONSTRUCTION ) CONTINUED
STEP 7
WARNING
Use only on 20 ampere branch circuit.
This fan heater must be properly grounded.
CAUTION
Wiring procedures and connections shall
be in accordance with the national and
local codes having jurisdiction.
Mount junction box cover carefully so
that lead wires are not pinched.
Refer to WIRING DIAGRAM
(See page 8).
Follow all local electrical safety
codes as well as the National
Electrical Code (NEC). Using UL
approved wire nuts, connect house
power wires to fan heater wires.
(Fig.5)
STEP 8
WARNING
Secure the machine screw (M4X8)
to the suitable hole tightly without
interfering the Flex-Z Fast™ bracket
for ground continuity. Take care to
avoid crossing or stripping the threads.
Carefully insert the fan body into the adaptor,
so that the body is all the way seated, and align
the flange of the body with the Flex-Z Fast™
bracket.
Secure fan body to Flex-Z Fast™ bracket
using 2 self-drilling screws, plug connector to
receptacle and secure fan body to adaptor with
the machine screw (M4X8). (Fig.6)
STEP 9
Finish ceiling work. Ceiling hole should be
aligned with the inside edge of the flange.
(Fig.7)
10
English
Conduit
Junction box
Live
*
(N.Light
)
Neutral
(Common for
Light and
*
N.Light
)
Live (Light)
*
Night Light
2 Self-drilling
screws
After finishing the ceiling job, fill gap between flange
and ceiling with caulk or other sealant to prevent air
leakage.
For Live (Heat) and Neutral (Common for
Heat and Vent), AWG 14 or more must
be used when wiring.
When making wiring connections take
care to prevent excessive slack in the
wiring since a large of current is drawn
through the heater electrical wire.
Earth ground
Neutral
Live (Vent)
(Common for Heat and Vent)
Live (Heat)
Receptacle
Ceiling drywall
WHITE
BLACK
BLUE
GREEN
RED
Wire nuts
Switch box
L
120 VAC
N
LINE IN
Earth ground
Fig.5
Plug
connector
Machine screw
(M4X8)
Fig.6
Unit: inches (mm)
Fig.7
Hide quick links:
Advertisement
Table of Contents
