Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
1. For a MPT-HL/MPT-HLC transceiver radio connected to an EASv2 or P8ETH
2. Install the appropriate radio/transport card in adjacent slot 4, 6, or 8 that is
3. On the CT settings window, enable the card as required. Enable the appropriate
4. On the CT settings window, configure the radio direction protection type as 1+1
5. Connect the new radio direction cables to the spare radio card that you installed
card, a second EASv2 or P8ETH card must be installed in the adjacent slot if not
already equipped. Install the MPT-HL/MPT-HLC transceiver in slot 2 of the
MPT-HL shelf.
For a MPT-HLC/HLS transceiver radio connected to a Core-E card port 5 or
MSS-1 shelf port 5, port 6 must be available to support the spare transceiver.
For MPT-HLC, install the spare transceiver in slot 2 of the MPT-HL/HLC shelf.
For a MPT-HLC/HLS transceiver radio connected to a CorEvo card port 7, port
8 must be available to support the spare transceiver. For MPT-HLC, install the
transceiver in slot 2 of the MPT-HL/HLC shelf.
For MPT ODU radio that is equipped with a MPTACC card, the spare radio hop
is supported on port 2 of the same MPTACC card or from an MPTACC card
installed in adjacent slot to the main MPTACC card, slots 4, 6, or 8. Install the
MPTACC as required, as described in the site documentation.
For MPT ODU radio connected to an EASv2 optical port equipped in slot 3, 5, or
7, a second EASv2 card must be installed in the adjacent slot 4, 6, or 8 if not
already equipped.
For MPT ODU radio connected to a Core-E card port 5 or MSS-1 shelf port 5,
port 6 must be available to support the spare MPT ODU radio.
For MPT ODU radio connected to a CorEvo card port 7, port 8 must be available
to support the spare MPT ODU radio.
associated with main radio direction. An Unconfigured Equipment Present
condition is raised.
radio, MPT ODU/MPT-HL/MPT-HLC transceiver that you installed in step 2.
HSB(SD) or 1+1 FD. Local station and remote station observes 2 second sync
loss.
in step 2, as described in the site documentation.
a. For a radio that is equipped with MPT-HL/MPT-HLC transceiver, install the
SFP into the appropriate Core-E/EASv2/P8ETH/MSS-1 SFP port and the
MPT-HL/MPT-HLC transceiver SFP port. Connect the fiber optic cable
between the SFP port and MPT-HL/MPT-HLC transceiver SFP port.
Connect the MPT-HL/MPT-HLC transceiver power cable, as described in
the site documentation.
b. For a MPT ODU radio that is equipped with a Core-E/EASv2/MPTACC/
MSS-1, connect the radio cables, as described in the site documentation
(optical Ethernet and power coaxial cable, electrical Ethernet and power
coaxial cable, or electrical Ethernet W/PFoE connectivity).
Upgrade and downgrade protection
1051
Advertisement
Table of Contents
