Change Oil In Swing Machinery Case And Electric Swing Motor Case - Komatsu HB365LC-3 Operation & Maintenance Manual

MAINTENANCE PROCEDURE
REMARK
Leave the machine as it is for at least 5 minutes, and then start the operation. This will remove the air bub-
bles in the oil inside the tank.
13. Check that there is no leakage of oil and wipe off any oil that is spilled.
CHANGE OIL IN SWING MACHINERY CASE AND ELECTRIC SWING MOTOR
CASE
Immediately after the engine is stopped, its parts and oil are still very hot, and may cause burn injury.
Wait for the temperature to go down, and then start the work.
Items to be prepared
Container to catch the drained oil
Change the oil in the swing machinery case and electric swing motor case according to the following table.
Item
Electric swing motor
case
Swing machinery case
1.
Remove the undercover (A).
2.
Place the containers to catch the oil under the drain plug
(P) for the swing machinery at the bottom of the machine,
and under the drain plug (Q) for the electric swing motor.
3.
Loosen the drain plug (P) for the swing machinery at the
bottom of the machine and the drain plug (Q) for the elec-
tric swing motor, and drain the oil. After draining oil, tighten
them.
REMARK
• If the oil becomes thin thread condition, there is no
problem to stop the draining operation.
• To reduce the oil draining time, swing the upper struc-
ture to increase the oil temperature slightly, then drain
the oil. Never swing the upper structure while draining
the oil. This may cause breakage of the swing machi-
nery.
4.
Remove the dipstick (G) from the oil filler port (F) of the
swing machinery, and add the refill capacity of oil.
5.
Remove the dipstick (K) from the oil filler port (J) of the
electric swing motor, and add the refill capacity of oil.
6.
Check the oil level with the dipstick (G) of the swing machi-
nery and the dipstick (K) of the swing motor. For detail, see
"METHOD FOR CHECKING OIL LEVEL IN SWING MA-
CHINERY CASE, ADDING OIL (4-61)" and "METHOD
FOR CHECKING OIL LEVEL IN ELECTRIC SWING MO-
TOR CASE, ADD OIL (4-62)".
4-66
k k
Type of oil
Power train oil TO10 (Ko-
matsu genuine)
Power train oil TO30 (Ko-
matsu genuine)
WARNING
Refill capacity
3.0 ℓ
15.6 ℓ
MAINTENANCE
Replacement or cleaning interval
Every 1 years or
1000 hours, whichever comes sooner