DeWalt DCE080RS Manual page 21

Pairing the Laser to a Remote
To pair the laser unit to one remote, simultaneously press and hold
on the laser keypad and
15˚/45˚/90˚ 15˚/45˚/90˚
and the remote will indicate that they are paired (in Private mode).
• The laser unit will beep twice and the locked
) on the laser keypad will blink twice and then remain green
4
to indicate that currently only one remote can control the laser
(Figure )
L
• The locked LED on the remote (Figure
then remain red.
If You Stop Using a Paired Remote
If you stop using a remote that has been paired with a laser unit (remote
is in Private mode), the remote will automatically reset back to Public
mode. You will not be able to use the remote to control the laser unit. The
Lock LED on the laser keypad will remain lit, but you can only use the
laser keypad to control the laser.
If...
No buttons are pressed on the
remote keypad right after it is
paired with a laser unit.
Buttons are pressed on the
remote keypad after it is paired
with a laser unit.
To change the remote back to Private mode so it can again control the
laser unit, press and hold on the remote keypad.
15˚/45˚/90˚
If You Turn OFF a Paired Laser Unit
If you use the laser keypad to turn off a laser unit that is paired with a
remote, turning the laser back on will not automatically re-establish the
Private connection with the same remote again.
• The remote that had been paired with the laser unit will remain in
Private mode with the Lock LED still lit, but it will not be able to control
any laser unit.
• The laser unit will default to Public mode and can be controlled by any
remote except the remote that is still in private mode.
on the remote. LEDs on the laser
LED (Figure
) will blink twice and
B 8
Result
Within 1 minute, the remote will
be reset back to Public mode.
After 8 hours, the remote will be
reset back to Public mode.
To unlock the remote and reset it back to Public mode so it can be used
to control any laser unit again, press and hold the RPM button on the
remote keypad.
Resetting a Remote from Private Mode
When a remote is in Private Mode with a laser unit, you may need to
A
reset the remote in order to use it with the laser unit again.
Scenario
When pressing and holding
on the laser keypad, the
15˚/45˚/90˚
laser entered No Remote
mode.
The laser unit entered
Private mode while paired
with another remote.
If the Lock LED is lit on
the remote, the remote has
been paired with another
rotary laser.
Controlling the Laser from up to 30m Away
You can use Bluetooth ® capability to pair the laser with the
D WALT Tool Connect™ application on your cell phone, and then
®
E
use your cell phone to control the laser (Figure
From either
1.
Tool Connect™ application to your cell phone and then open the
application.
On the laser's keypad, press
2.
How to Recover
On the laser keypad, press and hold
the RPM button to return the laser to
Public mode so it can be controlled by
any remote.
Reset the laser unit back to Public
mode. On the laser keypad, either:
• Press for 3 sec to turn the
power off and then press
to turn the power back on, OR
• Press and hold the RPM button.
Press and hold the RPM button on the
remote to reset it to Public mode.
).
I 2
or , download the DEWALT
to turn the laser on.
GB
again
®
21