Indracontrol Pr21 - Bosch rexroth Automax 100 Operating Instructions Manual

Commissioning | Automax 100 | Extension module TS-AC E2-M3-1X
It should be noted that the participants must be assigned different addresses in the 4th
octet. Double assignment of addresses in the 4th octet leads to IP address conflicts
between the participants.
The static IP address (Factory settings) of the embedded computer „IndraControl PR21" is
used as the basis for the IP address range. In delivery state or after a factory reset, the
static IP address of the IndraControl PR21 is set to 192.168.0.1.
Check that the IP address of the IndraControl PR21 conforms to the factory setting
(192.168.0.1). If the IP address assigned to the IndraControl PR21 differs from the factory
setting, please perform one of the following steps.
 Configure the IP address of the IndraControl PR21 to 192.168.0.1
 Reset the IndraControl PR21 to factory setting
For information on changing the network configuration of the IndraControl PR21, refer to the
application description „IndraControl PR-, VR-, DR- and DE Devices Software Applications".
See chapter „Required and supplementary
Use of the standard IP address (factory setting) of IndraControl PR21 as basis may deviate
in the following cases:
 Use of additional extension modules
 Exercise instructions
The following figure illustrates an overview of the IP addresses to be set (bold)

IndraControl PR21

Bus coupler
Overview of IP address to be set
IndraControl PR21
The static IP address (factory setting) of IndraControl PR21 is 192.168.0.1. The address
range is respectively defined as 192.168.0.
Instructions for changing of this IP address can be found in the „IoT Gateway, Quick Start
Guide". application description. Information on reference to this documentation can be
found in chapter „Required and supplementary
ATTENTION! For operation, IndraControl PR21 must be activated by pressing the power
push button. The position of the power push button is illustrated in the figure
PR21" as of page [22].
documentation" as of page [1].
PC
documentation" as of page [1].
Bosch Rexroth AG | 05.2021 | DOK-SUPPL*-TS-AC E2-M3-ITRS-EN-P
55/94
„IndraControl