Toshiba ASD 9 Series Manual page 21

F015 — V/f Pattern establishes the relationship between the output frequency and the output voltage.
When using the Easy Position PID function set this parameter to 8 - PG Vector Feedback Control
(Speed/Torque).
F201, F203— V/I Input Point 1, 2 Setting set the two points that establish the V/I response slope. These
two settings are entered as a percentage of F011. See
of F201 – F204 is also explained in detail in the ASD Operation Manual.
F202, F204 — V/I Input Point 1, 2 Frequency set the corresponding frequencies to the V/I Input Point
1 and 2 settings. See
F210, F212— RR Input Point 1, 2 Setting set the two points that establish the RR response slope. These
two settings are entered as a percentage of F011. See
of F210 – F213 is also explained in detail in the ASD Operation Manual.
F211, F213 — RR Input Point 1, 2 Frequency set the corresponding frequencies for the RR Input Point
1 and 2 settings. See
F216, F218— RX Input Point 1, 2 Setting set the two points that establish the RX response slope. These
two settings are entered as a percentage of F011. See
of F216 – F219 is also explained in detail in the ASD Operation Manual.
F217, F219 — RX Input Point 1, 2 Frequency set the corresponding frequencies for the RX Input Point
1 and 2 settings. See
F240 — Start Frequency sets the minimum motor speed during startup at which the ASD will begin to
output the commanded frequency even if the command frequency is less than the Start Frequency.
During the startup period from stopped until the Start Frequency is reached, the ASD does not output a
command frequency.
F241 — Run Frequency sets the center run frequency for the motor.
F242 — Run Frequency Hysteresis sets a plus-or-minus bandwidth for the Run Frequency. See the
ASD Operation Manual for details.
F243 — End Frequency sets the lowest frequency that an ASD will recognize before the ASD output
drops to 0.0 Hz.
F270, F272, F274 — Jump Frequencies 1, 2, 3 are used in conjunction with the Jump Frequency
Bandwidth. The Jump Frequency is the center frequency of a range specified by Jump Frequency
Bandwidth. See the appropriate ASD Operation Manual for details of Jump Frequency processing.
F271, F273, F275 — Jump Frequency Bandwidths 1, 2, 3 sets a plus-or-minus bandwidth for the
corresponding Jump Frequency.
F359 — PID Control Switching is used to set the PID control mode. It disables/enables PID feedback
control. Set this parameter to enable PID and select the feedback source.
0: PID Off
1: Process PID
2: Speed PID
3: Easy Positioning PID
PID Control Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Specify the Feedback Response on pg.
Specify the Feedback Response on pg.
Specify the Feedback Response on pg.
Specify the Feedback Response on pg.
4.
Specify the Feedback Response on pg.
4.
Specify the Feedback Response on pg.
4.
4. The use
4. The use
4. The use
13