Module Parameters" Parameter Group - Siemens SIMATIC Ident Operating Instructions Manual

Configuration and parameter assignment
4.3 Parameter assignment with the device configuration
For reasons of compatibility with the communications modules (e.g. RF18xC), you also have
the option of setting parameters for the RF120C using special Reset blocks. You can find
detailed information on the Reset blocks in the function manual "Ident profile and Ident
blocks, standard function for Ident systems
(https://support.industry.siemens.com/cs/ww/en/ps/14970/man)".
The "Parameter" main menu item is divided into the following parameter groups:
• Module parameters
• Frame (only for "MOBY Mode = Freeport")
The parameters of the communication module RF120C as of V2.0 are described below.
4.3.1

"Module parameters" parameter group

In this parameter group, you can configure all module-specific parameters of the
communication module.
Table 4- 1 Parameters in the "Module parameters" parameter group
Parameter
User mode
MOBY mode
Transmission
speed
22
Parameter value
Ident profile
RF200/RF300;
MV400/MV500
Freeport
MV320
RF1000
19.2 kBd
57.6 kBd
115.2 kBd
Default value Description
Ident profile Selection depends on the communications
module and Ident system being used. With this
parameter, you select the block:
•
RF200/RF300; With this parameter, you set the mode of the
MV400/MV500 communication module.
115.2 kBd Selection depends on the communications
module and Ident system being used. Note that
the value specified here is adopted automatical-
ly from the device configuration of the connect-
ed devices.
With this parameter, you set the data transmis-
sion speed between the communications mod-
ule and reader.
When an RFID reader is connected: After chang-
ing the transmission speed, the reader must be
turned off and on again (cycle power).
When an optical reader is connected: The
transmission speed selected here must match
the transmission speed selected in the firmware
of the reader.
Operating Instructions, 02/2021, C79000-G8976-C328-03
Ident profile:
The program block for the Ident profile is
used in the controller.
SIMATIC RF120C