Table 2-1 Functions And Settings Of The Dip Switches On The Panel Of The Emu - Huawei EMU User Manual

2 Overview of the EMU

Table 2-1 Functions and settings of the DIP switches on the panel of the EMU

Silkscreen
SW_ADDR
SW_BKE
SW_THE
SW_AE
SW_AV
2-6
Function
Selection of the
communication protocol
Bit 1: water sensor setting
Bit 2: smoke sensor setting
Bit 3: infrared sensor setting
Bit 4: door status sensor
setting
Bit 1: temperature sensor
setting
Bit 2: humidity sensor setting
Four bits for analog signal
sensor settings
Four bits for analog signal
sensor settings
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Setting
If a DIP switch bit is set to ON, it
l
represents 0. If a DIP switch bit is set to
OFF, it represents 1.
The settings of the DIP switch
l
SW_ADDR (1234) are as follows:
CDMA BTS or non-double-density
–
GSM BTS: 0001
Double-density GSM BTS or
–
WCDMA NodeB: 0010
This bit is set to ON if a sensor is not used.
l
This bit is set to OFF if a sensor is used.
l
This bit is set to ON, no matter whether a
sensor is used.
This bit is set to ON if a sensor is not used.
l
This bit is set to OFF if a sensor is used.
l
This bit is set to ON if a sensor is used.
l
This bit is set to OFF if a sensor is not
l
used.
This bit is set to ON if a sensor is used.
l
This bit is set to OFF if a sensor is not
l
used.
This bit is set to ON if a sensor is used.
l
This bit is set to OFF if a sensor is not
l
used.
Each bit corresponds to an analog sensor.
This bit is set to ON if a sensor is used.
l
This bit is set to OFF if a sensor is not
l
used.
Each bit corresponds to an analog sensor.
This bit is set to ON if a current-type
l
sensor is used.
This bit is set to OFF if a voltage-type
l
sensor is used.
EMU
User Guide
Issue 13 (2009-12-30)