Huawei FusionModule500 Quick Manual page 9

(Optional) Installing a Server
4.5
It is recommended that the server be installed at the 33–34 U position of the cabinet. You can
adjust the position based on site requirements.
1. Determine the installation position of the server and check whether floating nuts are
installed. If not, install them first.
2. Install guide rails.
5. Connect the power cable of the server.
a. Wear an ESD wrist strap or ESD gloves.
b. Connect one end of the power cable to
the cable port on the AC power module of
the server.
d. Route the power cable along the cable tray neatly, use cable ties to bind the power
cable, and use diagonal pliers to trim off the excess of the cable ties.
3. Place the server on the guide rails
and push it in to the cabinet.
4. Secure the server.
c. Use a hook-and-loop fastener to
secure the power cable.
9