Advertisement
Appendix
Loading NE Data by Using the Web LCT
The OAU 2A can connect to the Web LCT through its NMS port using a network
cable or communicate with the Web LCT through its WLAN module.
NMS port
Connect the Web LCT to this
port only when the GE2(e)
port is in use.
Open the maintenance compartment.
2
Connect a laptop running the Web LCT to the GE2 or NMS port of the OAU 2A using a network cable.
3
Use the Web LCT to configure NE data. For details, see the Commissioning and Configuration Guide.
4
Close the maintenance compartment.
• Prevent moisture from entering the NMS port during commissioning.
• After NE data is loaded, remove the network cable and close the maintenance
compartment.
Maintenance
compartment
GE2(e) port
Connect the Web LCT to
this port preferentially.
WLAN
module
A WLAN module was inserted into the USB port before the OAU 2A was delivered.
1
Use the WLAN Connection tool delivered with the Web LCT to set up a WLAN
connection between the Web LCT and OAUT 2A. For details, see "Connecting the
Web LCT to the Equipment" in the Commissioning and Configuration Guide.
2
Use the Web LCT to configure NE data. For details, see the Commissioning and
Configuration Guide.
25
USB port
compartment
Advertisement
