Advertisement
Appendix
Installing an Alignment Scope
1
Remove the rubber plugs from the screw
holes reserved for installing the alignment
scope on the antenna mounting bracket.
Rubber plug
3
(Optional) Install support rod B.
Use M6 hex socket
screws M6 to connect
support rods A and B.
• Install only support rod A for a 0.2 m or 0.3 m antenna.
• Install both support rods A and B for a 0.6 m or larger antenna.
56/57 >>
2
Install support rod A on the antenna mounting bracket.
Loosen the locking ring, adjust the support plate for
4
easy installation, and partially fasten the locking ring
to secure the objective lens tube in place.
Locking ring
Loosen
Tighten
5
Secure the alignment scope to the support rod.
Handwheel
Captive
screw
Loosen the locking ring, adjust the
6
alignment scope to the desired angle, and
tighten the locking ring.
Support
plate
Eye lens tube
27
Alignment scope
Adjust the antenna horizontally or vertically
7
until crosshairs line up on the target tower
or pole.
Advertisement
