Packing And Shipping The Machine - Brother DCP-395CN User Manual

Packing and shipping
the machine
When you transport the machine, use the
packing materials that came with your
machine. Follow the instructions below to
properly pack your machine. Damage caused
to your machine during transit is not covered
by your warranty.
IMPORTANT
It is important to allow the machine to
'park' the print head after a print job. Listen
carefully to the machine before
unplugging it to make sure that all
mechanical noise has stopped. Not
allowing the machine to finish this parking
process may lead to print problems and
possible damage to the print head.
a
Open the ink cartridge cover.
b
Press the ink release lever to release
the ink cartridge and take out all the ink
cartridges.
(See Replacing the ink cartridges
on page 82.)
c
Install the green protective part and then
close the ink cartridge cover.
Troubleshooting and Routine Maintenance
IMPORTANT
• Make sure that the plastic tabs on both
B
sides of the green protective part (1) have
securely clicked into place (2).
1
• If you are not able to find the green
protective part, DO NOT remove the ink
cartridges before shipping. It is essential
that the machine be shipped with either
the green protective part or the ink
cartridges in position. Shipping without
them will cause damage to your machine
and may void your warranty.
d
Lift the front of the machine and hook
the long end (1) of the green protective
part into the T-shaped hole underneath
the machine. Push the forked end (2)
onto the top of the paper tray.
2
2
1
91
B