Setting The Signal Type - Silvercrest STK 36V2 A1 Assembly, Operating And Safety Instructions

Press the chime button
programmed audible signal sounds and the signal indicator
ceases to illuminate when
selected by the signal type selector sliding switch
If the receiver does not react as described, press the synchronisation
button
2
repeat the synchronisation process.
The transmitter indicates the transmission of the signal to the receiver by
the signal indicator

Setting the signal type

The receiver can indicate the reception of a door signal either acoustically
or optically or both optically and acoustically.
Using the signal type selector sliding switch
the signal is to be indicated acoustically or optically or both optically
and acoustically.
Note: When the battery of receiver is drained, signal indicator
flash. You can replace the used battery with a new one of the same type.
14 GB/IE/NI
; the signal indicator
12
,
again to switch off the synchronisation function and
flashing briefly.
10
1
optical and acoustic signal is
flashes red. The
1
.
5
, select whether
5
will
1