Handling And Operation; Power Supply: Receiver; Setting The Signal Type - Silvercrest STKK 16 B1 Operating Instructions Manual

Handling and operation

Power supply: receiver

The receiver is plugged into a properly installed
mains power outlet and does not require batteries .

Setting the signal type

The receiver can indicate the reception of a door-
ring signal either acoustically and optically, or only
optically .
♦ Press the signal type selection button
select the acoustical and optical signal: when
pressing the ringer button 7, a ringer tone
sounds and the signal LED 4 flashes white .
♦ Press the signal type selection button
again to select only the optical signal:
There is no ring when pressing the ringer 7
button . Instead, the signal LED 4 flashes green
and blue six times, then flashes green four times
and finally stays green for 10 seconds .
STKK 16 B1
GB │ IE │ NI
1 to
1
│ 13 ■