Mounting The Transmitter - Silvercrest STKK 16 B1 Operating Instructions Manual

Mounting the transmitter

NOTE
► You will need a Phillips screwdriver and a drill
with a 5 mm drill bit to mount the transmitter .
► Only use the screws t and wall plugs r
provided to mount the transmitter .
► Ensure that there are no electric lines, water or
heating pipes installed at the proposed drilling
location!
► The supplied wall plugs r are only suitable for
mounting in concrete or stone . Before starting
the installation, please check your installation
location carefully for its suitability for the wall
plugs r . The assembly material must be suita-
ble for the respective location .
If in doubt, consult a professional .
► Alternatively, you can mount the transmitter
using the double-sided adhesive tape w onto a
suitable surface (maximum height 2 m) .
♦ Select a suitable positioning for the transmitter,
close to your outer door .
■ 16 │ GB │ IE │ NI
STKK 16 B1