No.
Working STEP
End processing
2
Attaching
the
3
terminals
Appendix. Processing the ends of the coaxial cable
Description of work
Remove the insulation.
(5)
Remove the insulation, but leave approximately 5mm from
the end of the clamp.
*Take care not to damage the central semi-conductor when
removing the insulation.
Prepare the central semi-conductor for soldering.
(6)
Take care not to apply heat to the insulation when preparing
it for soldering.
Insert the terminal in the central semi-conductor.
(7)
Solder the central semi-conductor to the terminal.
(8)
Heat the terminal and solder from the hole on the side of the
terminal.
After soldering.
(9)
Remove any excess solder with a solder wick or knife if it
has leaked outside the terminal.
Coaxial cable
Appendix-5
Approx. 5mm
(insulator)
Approx. 5mm
(center conductor)
Insulator
Center conductor
Soldering iron
Fit
Solder
Soldering iron
Terminal
Remove
excess
solder
Remark
Soldering iron
100W