Loading The Module; Precautions During Installation - Hitachi EH-150 Applications Manual

5.1.2 Loading the Module

(1) Installing
(2) Removing
3]

5.1.3 Precautions during installation

As shown in figure 5.2, when coaxial cables are connected to the link module, they will protrude by
approximately 75mm from the link module' front panel. Take care to ensure that the door or other areas do
not come into contact with the cable when designing the control panel. Also, ensure that the weight of the
cable is not applied directly to the connector during connection.
Enclose the coaxial cables with the insulation
tube supplied to avoid touching it.
Figure 5.2 Link modules connected with coaxial cables
2]
1]
1]
2]
Approx. 75mm
Fix the cable in place with the
cable clamp.
5-2
Chapter 5. Installation and start-up
1] Hook the claw at the lower section of the
module to the hole in the base.
2] Press in the upper side of the module until
it clicks.
Note 1: After loading the module, check to
make sure it does not come out.
Note 2: Load the power module at the leftmost
side of the base unit.
Note 3: Load the CPU module and I/O
controller to the left of the power
module.
1] Push in the lock button.
2] With the lock button pushed in, pull the
top of the module toward the front.
3] Raise it toward the top and pull it out.
Note: For the power module, pull it out
while pushing down the two lock
buttons.