Brother HL-1800 Series User Manual page 168

H o w t o P
H o w t o P
Problem
The printer prints unexpectedly
or it prints garbage.
The DL size of envelopes that
have been creased after they
were printed.
The printer cannot print full
pages of a document. An error
message "PRINT OVERRUN"
occurs.
The printer cannot print full
pages of a document. A
"MEMORY FULL" error
message occurs.
r i n t C o r r
r i n t C o r r
Recommendation
•
Make sure the printer cable is not too long. We recommend you
use a parallel cable that is less than 2 metres (6 1/2 feet) long.
•
Check if the printer cable is damaged or broken.
•
If you are using an interface-switching device, remove it, and
then connect your computer directly to your printer and try again.
•
Check that you have chosen the appropriate printer driver as 'Set
as Default'.
•
Check that the printer is not connected to the same port that is
also connected to a storage device or scanner. Remove all other
devices and connect the port to the printer only.
•
Turn off the status monitor in the Device / Options page on the
Advanced tab in the printer driver.
•
Put in new DL size envelopes sideways, and print again.
'Printing Envelopes' in Chapter 1.
•
Press the
•
If this does not clear the error, reduce the complexity of your
document or reduce the print resolution.
• Change the following settings in the supplied Windows
and then try again. The best combination of settings below will
vary depending on your document.
•
•
•
• Press the
•
Reduce the print resolution or reduce the complexity of your
document.
•
Expand the printer memory by adding a commercially available
DIMM.
e c t l y
e c t l y
Go
button to print the data that is left in the printer.
Graphics mode
TrueType mode
Use Printer TrueType Fonts
Go
button to print the data that is left in the printer.
Refer to 'RAM Expansion' in Chapter 4.
6-29
CHAPTER 6 TROUBLESHOOTING
Refer to
®
driver,