Husqvarna S 13 Workshop Manual page 20

4. Remove the manometer tube.
5. Remove the 3 nuts and remove the motor tube.
6. Disconnect the cables from the circuit board for the
part that is necessary to remove.
G
H
I
D
E
20 - Repair instructions
a) To disconnect the circuit board (A), remove all
the cables from the circuit board.
b) To disconnect the ON/OFF switch (B), remove
the cables from the ON/OFF switch.
c) To disconnect the power cord (C), remove the
brown (D) and blue (E) cables from the ON/OFF
switch (B) and the ground cable (F).
d) To disconnect the motor, remove the ground
cable (G) and the black (H) and white cable (I)
that are attached to the circuit board.
8.5.2 To replace the ON/OFF switch
1. Remove the motor tube. Refer to
circuit board (S 13) on page 19 .
2. Make a note of the positions of the cables on the
ON/OFF switch.
3. Disconnect all the cables from the ON/OFF switch.
4. Push the ON/OFF switch out of the socket.
5. Connect the cables to the new ON/OFF switch.
Refer to the illustration and the table.
F
A
B
C
G
F
D
C
To disconnect the
E
B
A
1347 - 001 -