6. Remove the 4 screws at the bottom of the motor
housing. Remove the 2 screws on the inner side of
the inlet.
7. Remove the 6 screws that attaches the inlet to the
motor housing. Remove the inlet.
8. Remove the 6 screws on the back plate. Remove
the rear plate.
9. Tilt the motor housing slightly rearward for wire and
cable access.
1347 - 001 -
10. Remove the wires that go into the ON/OFF switch.
Remove the manometer tube.
11. Loosen the 5 nuts that attach the ground wires to the
motor housing.
12. Pull the motor housing up and remove the motor
housing.
Repair instructions - 25