Vertical Steam Ironing; Refilling With Water - Silvercrest SDBS 2400 B2 Operating Instructions Manual

Vertical steam ironing

♦ Hang the fabric to be ironed on a clothes hanger which is hung against a
heat-resistant surface .
♦ Insert the plug into a mains power socket .
♦ Set the On/Off switch w to the position "1" to switch the appliance on . The
integrated control lamp in the On/Off switch w and the heat-up indicator
lamp 3 light up, the "MAX" button z flashes .
♦ Turn the temperature control 4 to set the required ironing temperature . The
temperature control 4 must be set within the
♦ The heat-up indicator lamp 3 lights up during heating . As soon as the set
temperature has been reached, the heat-up indicator lamp 3 goes out .
♦ Adjust the steam power:
–
Press the "MAX" button z to create maximum steam .
–
Press the "ECO" button tto produce less steam .
♦ As soon as the "MAX" z or "ECO" button t lights up continuously
(depending on the setting), you can start steam ironing .
♦ Hold the steam iron in a vertical position and press the steam button 5 .
♦ Touch the fabric lightly with the sole of the iron 6 and steam it to remove
creases .
♦ Release the steam button 5 to stop the appliance producing steam .
♦ Put the iron down on the stand 7 on the base station q after ironing .
Set the temperature control 4 to "min" .
♦ Set the On/Off switch w to the position "0" to switch the appliance off . The
integrated control lamp in the On/Off switch w and the steam control lamp
"MAX" z or "ECO" t go out .
♦ Pull the plug out of the mains socket .

Refilling with water

You can refill the appliance with water while it is switched on .
♦ Put the iron down on the stand 7 on the base station q .
♦ Refill the water as described in the section "Filling the water tank" .
■ 14 │ GB │ IE │ NI │ CY
range to produce steam .
SDBS 2400 B2