Troubleshooting - Canon LV-S2 Owner's Manual

Before calling your dealer or service center for assistance, check the following:
1. Make sure you have connected a projector to your computer or video equipment as described in the section
"CONNECTING THE PROJECTOR" on pages 11 ~ 13.
2. Check cable connection. Verify that all computer, video and power cord are properly connected.
3. Verify that all power is switched on.
4. If a projector still does not produce an image, re-start your computer.
5. If an image still does not appear, unplug the projector from your computer and check your computer monitor's display.
The problem may be with your graphics controller rather than with the projector. (When you reconnect the projector, be
sure to turn the computer and monitor off before you power up the projector. Turn the projector on, and then the
computer.)
6. If the problem still exists, check the following chart.
Problem:
No power.
Image is out of
focus.
Picture is Left/Right
reversed.
Picture is
Top/Bottom
reversed.
Some displays are
not seen during the
Operation.
No image.
No sound.
40

TROUBLESHOOTING

G Plug the projector into your AC outlet.
G Make sure the READY Indicator lights.
G Wait 90 seconds after a projector is turned OFF before turning the projector back on.
NOTE : After pressing the Power ON-OFF button to OFF, make sure the projector works as
follows:
1. LAMP indicator lights bright and READY indicator turns off.
2. After 90 seconds, the READY indicator lights green again and the projector may
be turned on by pressing the Power ON-OFF button.
G Check WARNING TEMP. indicator. If the indicator flashes red, the projector cannot be
turned on.
(See "TURNING ON/OFF PROJECTOR" section on page 19.)
G Check Projection Lamp. (Refer to page 37.)
G Adjust focus of the projector.
G Make sure the projection screen is at least 3.6' (1.1m) from the projector.
G Check Projection Lens to see if it needs cleaning.
NOTE : Moving a projector from a cool temperature location to a warm temperature location
may result in moisture condensation on the Projection Lens. In such an event,
leave the projector OFF and wait until condensation disappears.
G Check Ceiling / Rear feature. (See "SETTING" section on page 35.)
G Check Ceiling feature. (See "SETTING" section on page 35.)
G Check Display feature.(See "SETTING" section on page 35.)
G Check the connection between your computer or video equipment and the projector.
G Check the NO SHOW function. (Refer to page 21.)
G When turning the projector on, it takes about 30 seconds to display an image.
G Check the system that you select is corresponding with your computer or video
equipment.
G Make sure the temperature is not out of the Operating Temperature (5°C ~ 35°C).
G Check audio cable connection from the audio input source.
G Adjust the audio source.
G Press the VOLUME (+) button.
G Press the MUTE button.
Try these Solutions
APPENDIX