Intended Use; Warranty And Liability For Defects - Beko METPOINT FLM SF53 Installation And Operating Manual

EN

1.5. Intended use

The METPOINT FLM is a thermal flow meter for the measurement of volume flow, consumption and flow velocity. In its default
®
setup, the device is configured for the measurement of volume flow in m³/h, consumption in m³ and velocity in m/s.
• The METPOINT FLM is primarily used in compressed air systems. On request, the sensor can be programmed by BEKO
®
TECHNOLOGIES GmbH for use with other gases: Nitrogen
• The device is not suitable for operation in potentially explosive or aggressive atmospheres.
• Protect the device against direct sunlight and heat radiation.
Operate the METPOINT FLM only for the intended purpose and within the specifications as stated in the technical data. Do not
®
operate the device with any media (fluids, gas/vapour mixtures) other than those listed above. Any other use of this system, which
exceeds the intended use, is hereby deemed to be improper and can cause a hazard for the safety of people and the environment.

1.6. Warranty and liability for defects

Warranty claims are voided if the METPOINT
limits specified in the technical data. Such uses include (but are not limited to) the following:
• Technically incorrect installation, incorrect commissioning, incorrect maintenance or incorrect operation
• Operation with defective components
• Non-compliance with the instructions in this manual and the safety instructions in particular
• Execution of constructive interventions or modifications on the device
• Failure to observe the prescribed maintenance intervals
• Use of third-party spare parts that have not been approved by the manufacturer for repair and maintenance work
METPOINT SF53
®
FLM is used for a purpose other than the intended use or operated outside the
®
Installation and operating manual
7