Table of Contents
Advertisement
EN
1.5. Intended use
The METPOINT
FLM is a thermal flow meter for the measurement of volume flow, consumption and flow velocity. By default, the
®
device is configured for the measurement of volume flow in m³/h, consumption in m³ and velocity in m/s.
•
The METPOINT
FLM is primarily used in compressed air systems. On request, the sensor can be programmed by BEKO
®
TECHNOLOGIES GmbH for the measurement of other gases: nitrogen, argon, helium, carbon dioxide
•
The device is not suitable for operation in potentially explosive or aggressive atmospheres.
•
Protect the device against direct sunlight and heat radiation.
Operate the METPOINT
FLM only for the intended purpose and within the limit range specified in the technical data. Do not
®
operate the device with any media (fluids, gas/vapour mixtures) other than those listed above. Any other use of the device is
deemed improper and poses a risk to persons, property and the environment.
1.6. Warranty and liability
All warranty shall be voided, if the METPOINT
outside the limits specified in the technical data. In such cases, the manufacturer shall also reject any liability for damages.
Improper operation includes:
•
Incorrect installation, commissioning or operation; insufficient maintenance
•
Operation with defective components
•
Non-compliance with the instructions in this document, in particular the safety instructions
•
Modification of the device
•
Non-compliance with the prescribed maintenance intervals
•
Use of third-party spare parts that have not been approved by the manufacturer
7
FLM is used improperly, for a purpose other than the intended or is operated
®
Installation and operating manual
METPOINT
SF53
®
Advertisement
Table of Contents
