EN
5. Start-up
To start the METPOINT
FLM, power it and perform the sensor setup as described in „Sensor Setup" auf Seite 28. Slowly
®
pressurise the pipes.
6. Configuration and operation
When the METPOINT
FLM is powered, it is automatically initialised. After this step is completed, the main menu is displayed.
®
The device menus are operated through two capacitive buttons:
>>UP<<
>>ENTER<<
6.1. Display during operation
Gasart /
Statusmeldung
HW-Version
SW-Version
Press the >>UP<< button to call up pages 2 - 5.
27
Modbus ID
Seiten Nr.
CAL
indicates that calibration is due:
After 15 months, message
device needs to be calibrated. This message does not have any
effect on the measuring process, and the device continues to
provide accurate measuring signals.
On request, the calibration interval can be adjusted at the
factory.
Installation and operating manual
CAL
is displayed, indicating that the
METPOINT
SF53
®