Assembly - Husqvarna 524LK Operator's Manual

WARNING:
may increase the risk of accidents.
WARNING:
cord is wound tightly and evenly around the
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
cable from the spark plug before you
assemble the product.
To assemble the loop handle
1. Put the loop handle onto the shaft, between the
arrows.
2. Put the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw. Do not
tighten fully.
4. Adjust the product to an applicable operation
position.
5. Tighten the knob.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
1309 - 004 - 23.03.2021
A faulty cutting attachment
Make sure that the trimmer

Assembly

Before you assemble the
Remove the spark plug
drum, otherwise the product will generate
harmful vibration.
• Only use cutting attachments with the guards we
recommend. Refer to
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
B
3. Carefully push the shaft into the coupling until you
hear a click.
4. Tighten the knob fully.
Accessories on page 22 .
A
11