Operation - Husqvarna 524LK Operator's Manual

To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the engine is
attached to.
4. Pull the attachment straight out of the coupling.
C
To assemble the cutting attachment guard and
trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head. Refer to
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
12
Accessories on page 22 .

Operation

Before you operate the
2. Put the cutting attachment guard onto the fitting on
the shaft.
3. Attach with the bolt (L).
A
4. Install the drive disc (B) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
6. Put the locking pin (C) in the hole to lock the shaft.
7. Turn the trimmer head /plastic blades (H) in the
opposite direction from which the trimmer head/
plastic blades rotates.
H
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
B
C
A
H
1309 - 004 - 23.03.2021