Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document require the following tools:
● Phillips #0 screwdriver
● Phillips #1 screwdriver
● Flat headed screwdriver
● Plastic scribe
Screw List
The following table shows the screw list and the images for different components.
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Side cover
M.2 2230/2280 Solid-state drive
WLAN card
Power supply unit
Processor fan and heat-sink assembly
System board
10
Removing and installing components
Screw type
Quantity
#6-32
2
M2x3.5
1
M2x3.5
1
#6-32
3
#6-32 (Captive)
4
#6-32
11
2
Image
Advertisement
Table of Contents
